Reliability and cost control are both things that transportation and infrastructure companies are held to maintain, but too often the contractors that work for them don’t show the same level of concern. At SES, we take pride in our ability to offer a professional and reliable workforce who can get your job done in a cost effective and safe manner.
We have experience with all levels of transportation; from trains to planes to boats. We also work heavily in municipalities, universities, hospitals, and prisons, and our industrial cleaning service is second to none.
Take a look at the items below to see some examples of the types of work we can offer your industry:
We vacuum out and then lance the lines in your storm water system to ensure that the lines are clean.
After the water is pumped out of the pit, we can go in and vacuum out the remaining sludge and complete a final rinse down with a hot pressure washer.
We can vacuum out your glycol pump stations.
We vacuum out all the waste from your clarifier and then we either pressure wash or firehose down the sidewalls and floors.
We vacuum out and then lance the lines in your lift station to ensure that the lines are clean.
We can vacuum out your valve stations.
We vacuum out all the sludge and solids from your digester, then we either pressure wash or firehose down the sidewalls and floors.
We can waterblast the bottom of your barge using our 20,000 to 40,000 psi water blasters in order to remove barnacles and other buildup.
Using our high powered vacuum trucks and hot pressure washers, we can clean both your fuel tanks and your bilge tanks on your barge.
We can clean any tanker or truck spills that happen at your distribution facility or warehouse. If the material is unidentified, our Emergency Response team can contain, identify, and then neutralize the situation.
We can use an assortment of different tools that attach to our water blasters in order to clean you warehouse floors.
We can dust bust your facility with or without a foam treatment. The foam treatment is quicker and reduces the amount of waste going off site.
Our high rails use a creeper drive system, and we can continuously vacuum while moving down the rail for ballast and spill cleanup. This is much more efficient than traditional means.
We can replace your absorbent track mats, and after we remove the mat we remove and clean any contaminated stone, and replace it with fresh stone.
We clean lube oil tanks, diesel fuel tank and dike cleanings, diesel fuel unloading areas, and other types of tanks you may have.
We can remove your legacy ties with a grappler machine to load the ties on trucks and haul them to your nearest landfill.
General clean sweep up of scrap, trash, legacy ties, exterior building cleaning, etc.
We can jet out your sewer drains, clean trenches out, and clean your concrete floors.
We can clean out your lift stations, separators, and all other components of your waste water collection system. We also offer competitive disposal to remove the waste water.
We can clean your oil tanks with our waterblasters and vacuum trucks. Oil tanks usually have a heavy sludge in them, and our methods provide an effective clean.
We use a vacuum truck to remove rainwater, hydraulic fluid, or other sediment from your elevator shaft.
After the water is pumped out of the pit, we can go in and vacuum out the remaining sludge and complete a final rinse down with a hot pressure washer.
We can vacuum out the material that has accumulated in the wet well.
We can lance out the wet side of the boiler tubes in your boiler house.
We can either lance or jet out your drain lines or process lines.